Showing 1–12 of 306 results
-
Starting at $196.20
Fast and accurate method of thread measuring available for use with Micrometer
-
Starting at $1,089.00
Specially designed to measure the distance between two centers or the distance from an edge to center.
Provided with jaws on the back of the slider, measurements can be read easily by looking down.
Direct reading of pitch measurements is available due to the offset value setting function.
With SPC data output.
Supplied fitted in wooden case. -
Starting at $193.50
Can be used in workshop conditions exposed to coolant, water, dust or oil.
Easy to use – no need to wipe or clean the scale.
Advanced design styling.
Incorporates absolute measurement system.
Automatic power-on/off.
Data output function.
With thumb roller.
Supplied in fitted plastic case. -
Starting at $843.30
Accuracy: Refer to the list of specifications.
Resolution: 0.01mm or .0005″/0.01mm
Display: LCD
Scale type: ABSOLUTE electromagnetic linear encoder
Max. response speed: Unlimited
Battery: SR44 (1 pc.), 938882
Battery life: Approx. 5,000 hours in continuous use
Dust/Water protection level: IP66
Standard accessory: Jaw clamps (2 pcs.), 05GZA033 -
Starting at $214.20
Designed with a back plunger type dial indicator for upward facing readings. (7231, 7237T, 7238T)
-
Starting at $486.90
•The rounded faces of the jaws are ideal for accurate ID (inside diameter) measurement.
•Inside and outside measurements can be directly read from the upper and lower slider graduations (Series 160).
•With fine-adjustment carriage type is available (Series 160).
•Parallax-free vernier scale type is available for easy and positive measurement (Series 160).
•With SPC output (Series 550).
•Supplied in fitted plastic case. Except 1000mm / 40” supplied in wooden case. -
Starting at $1,062.00
– The minimum value holding function provides the easy detection of hole diameter.
– Up to three sets of master value and upper/lower tolerance value can be memorized.
– An analog bar indicator is integrated to enhance the intuition in reading.
– GO/±NG judgment is performed by setting the upper and lower tolerances.
– Up to four rods (250mm or 500mm) can be used. -
Starting at $341.10
-
Starting at $133.20
Mitutoyo’s absolute Digimatic Caliper is the next generation of electronic calipers. It keeps track of its origin point once set. Whenever turned on, the large LCD displays the actual slider position ready to start measurement. No more repeated zero setting is necessary with the absolute encoder technology, as well as no more concern for over speed errors.
Large and clear LCD readout.
The ZERO/ABS key allows the display to be Zero-Set at any slider position along the scale for incremental comparison measurements. This switch will also allow return to the absolute (ABS) coordinate and display of the true position from the origin point (usually jaws-closed point).
Data Hold Unit (959143) is optional.
Carbide-tipped jaw type calipers are also available.
With thumb roller. Except 500-500-10, 500-501-10,500-502-10.
Supplied in fitted plastic case. Except 1000mm / 40” supplied in wooden case. -
Starting at $536.40
The rounded faces of the jaws are ideal for accurate ID (inside diameter) measurement.
With SPC output.
Supplied in fitted plastic holster in carton.18″/450mm and larger supplied wooden case. -
Starting at $469.80
– ABSOLUTE Digimatic Depth Gage can keep track of the origin point once set for the entire life of the battery.
– Base and measuring faces are hardened and micro-lapped.
– Optional wider extension base are available.
– With SPC data output.